TM-5-2815-241-34-P

ENGINE, DIESEL NTC-290

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT, MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

MARCH 1987

TM-5-2815-241-34-P - Page 227 of 738

TM 5-2815-241-34&P

CYLINDER HEAD - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

NOTE

To determine amount of cut to injector sleeve seat, measure tip protrusion. See steps 18

and 19.

When cutting injector sleeve seat, use a solid stream of good cutting fluid to allow cutter

to cut freely without grabbing.

48.

Cylinder head (20)

Injector sleeve (21)

Using ST-884 injector sleeve cutter (22)

and suitable drill press, cut injector

sleeve just enough to provide for proper

seating of injector and to maintain correct

injector tip protrusion. See steps 12

thru 16.

If Injector seating area or Injector

tip protrusion are not within specifi-

cations, recut Injector sleeve seat.

TA 242476

2-205