TM-5-3805-254-14-P-2
TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)
JUNE 1980
TM-5-3805-254-14-P-2 - Page 16 of 894
AXLE-FRONT
TRUCK SERVICE MANUAL
a. Bend-Over Type Locking Washer
Remove hub cap and gasket.
Bend locking
washer to release outer lock nut and inner wheel bearing
adjusting nut.
Remove outer nut, locking washer and
inner adjusting nut from steering knuckle spindle.
NOTE:
Always install new locking washer during
reassembly.
b. Dowel and Perforated Ring Type Locking
Washer
Remove hub cap and gasket.
Remove outer lock
nut,
locking
washer
perforated lock ring and doweled wheel bearing adjusting
nut from steering knuckle spindle.
3. Remove the outer wheel bearing cone.
4. Remove the wheel and hub assembly.
Steering Knuckle Removal
1. Remove wheel and hub.
2. Disconnect tie rod and drag link.
NOTE:
Straight knuckle pins may be removed
from the bottom of the knuckle where adequate
clearance is provided; however, on some models
such as those with riveted backing plates less
work is involved by tapping the knuckle pin out
the top of knuckle.
In either case the adjacent
parts, such as air chambers, hydraulic lines or
fittings, etc, that might cause an obstruction to
the knuckle pin, must be removed first.
3.
Remove the snap rings and expansion plug from
the bottom of the knuckles where employed.
If plug
employs no snap ring and is expanded and staked,
remove plug by use of a cape chisel and discard.
4.
Remove the cap screws or bolts, cover plate,
gasket or O-ring from top of knuckle or remove lock ring
retainer and seal, depending on model, Fig.
4.
Back to Top
