TM-5-3805-254-14-P-2
TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)
JUNE 1980
TM-5-3805-254-14-P-2 - Page 38 of 894
TRUCK SERVICE MANUAL
AXLE-REAR
REASSEMBLE CROSS SHAFT ASSEMBLY
A.
Check sleeve I.D. and radial bearing O.D. Replace
sleeve and/or bearing if the parts are damaged, or if
there is more that .006" clearance between the sleeve
and bearing. When these parts are new the sleeve
I.D. should be .0024" to .004" larger than the bearing
O.D. The radial bearing must be free to float in the
sleeve.
Carefully check the I.D. of the bearing bore of older drive units
that do not have replaceable sleeves. If the I.D. is more that
.006" larger that the bearing O.D., replace the carrier and cap
assembly with the newer type carrier and cap assembly that
incorporates replaceable sleeves.
B.
If radial bearing sleeve is to be replaced, press new
sleeve firmly against housing shoulder. Drill hole for
lock screw and remove burrs from sleeve. Install lock
screw and tighten securely or install pin and stake in
place.
Back to Top
