TM-5-3805-254-14-P-2
TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)
JUNE 1980
TM-5-3805-254-14-P-2 - Page 42 of 894
TRUCK SERVICE MANUAL
AXLE-REAR
2.
Turn adjusting screw (at front of unit) in, to
contact shift fork.
3.
After contact with fork has been made, turn
adjusting screw in, 3/4 of a turn.
4.
Lock adjusting screw in position with jam nut.
B.
Install shift unit into carrier engaging shift collar on
pinion quill assembly with shift fork.
C.
Assemble shift lever attaching nut, button, lever, cup
and spring.
D.
Install shift shaft housing assembly, lockwashers and
capscrews.
NOTE: Do not adjust shift shaft until interaxle differential has
been installed.
ASSEMBLE INTERAXLE DIFFERENTIAL
A.
Lubricate differential case walls and all component
parts with axle lubricant.
B.
Position thrust washer and rear side gear into rear
case section and assemble intermediate case section
over real case and side gear.
C.
Place spider with pinions and thrust washers in
position.
Back to Top
