TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 665 of 894

TRUCK SERVICE MANUAL

STEERING

3. If the steering wheel is removed, it is necessary

to replace the steering wheel nut to prevent the

steering shaft from sliding out of the steering

jacket tube.

See index for steering wheel

removal.

4. Remove turn signal control from steering

column.

5. Remove trailer brake control if mounted on

steering column.

6. Disconnect horn wire at the connector.

7. Remove the lower bracket cap, and cover over

universal joint from steering column, refer to Fig.

6.

8. Remove upper bracket cap and lift steering

column from cab.

Be careful not to tear the

rubber boot, or break the steering tube locating

pin in steering column mounting bracket.

When

reinstalling steering column the locating pin must

align with hole in steering jacket tube.