TM-5-3805-254-14-P-2

TRUCK, DUMP, 20 TON, 6X4, ON-OFF HIGHWAY 71,000 GVW, IHC MODEL F-5070 (CCE)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT AND DEPT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS INFORMATION AND SUPPLEMENTAL MAINTENANCE INSTRUCTIONS)

JUNE 1980

TM-5-3805-254-14-P-2 - Page 666 of 894

TRUCK SERVICE MANUAL

STEERING

UNIVERSAL JOINT REPLACEMENT

The universal joint at the steering gear may be

removed and serviced separately.

To service the upper

universal joint it is necessary to remove the steering

column.

Once the shafts and universal joints are

removed from the vehicle the procedure for servicing the

universal joint is as follows

NOTE:

Be careful not to damage

bearing surfaces.

1. Place universal joint in vise as shown in Fig.

8.

Remove snap ring fitting in grooves of the spider

bearings which locate them on the inside of the

yokes.

To remove snap rings; place a

screwdriver against an end of the snap ring and

push.