TM-5-3805-274-13-P

DUMP TRUCK BODY M917

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

AUGUST 2013
TM-5-3805-274-13-P

  TM-5-3805-274-13-P - Page 219 of 364

FIELD MAINTENANCE
LUBRICATION INSTRUCTIONS FOR M917 DUMP TRUCK BODY
INITIAL SETUP:
Materials/Parts
Cleaning compound, solvent (WP 0077, Item 1)
Cloth, cleaning (WP 0077, Item 2)
Grease (GAA) (WP 0077, Item 3)
Oil, lubricating, OEA (WP 0077, Item 4)
Oil, lubricating, OE/HDO 10 (WP 0077, Item 5)
Oil, lubricating, OE/HDO 30 (WP 0077, Item 6)
References
WP 0001
GENERAL
WARNING
Cleaning solvent is combustible. DO NOT use or store near heat,
sparks, flame, or other ignition sources. Use mechanical ventilation
whenever product is used in a confined space, heated above ambient
temperatures, or agitated. Keep container sealed when not in use.
Failure to comply may result in injury to personnel. Seek medical
attention in the event of an injury.
Hard time intervals and related man-hour times are based on normal operation. The man-hour time specified is
the time you need to do all the services prescribed for a particular interval. Charge the hard time interval if
your lubricants are contaminated or if you are operating the equipment under adverse operating conditions,
including longer-than-usual operating hours. The hard time interval may be extended during periods of low
activity. If extended, adequate preservation precautions must be taken.
Clean parts or fittings with cleaning compound solvent Type II or equivalent. Dry before lubricating. Dotted
arrow shaft indicates lubrication on both sides of equipment. A dotted circle indicates a drain below.
Relubricate: all items found contaminated after fording or washing.
The lowest level of maintenance authorized to lubricate a point is indicated by one of the following symbols
as appropriate: Operator/Crew (C) and Field Maintenance (F).
LUBRICATION CHART
USAGE
FLUID/LUBRICANT
CAPACITIES
EXPECTED
TEMPERATURE
HINGES, LATCHES, ACCESS DOOR, CONTROL LINKAGE
(MIL-PRF-2104)
(81349)
OE/HDO
As required
Above +15° F
(-9° C)
(MIL-PRF-46167)
(81349)
OEA
As required
+40° to -65° F
(-4° to -45° C)
HYDRAULIC RESERVOIR OIL
(MIL-PRF-2104)
(81349)
OE/HDO
Reservoir 20 gal. (75.68 L)
Fill to center mark on sight
glass
Above +15° F
(-9° C)
(MIL-PRF-46167)
(81349)
OEA
Reservoir 20 gal. (75.68 L)
Fill to center mark on sight
glass
+40° to -65° F
(-4° to -45° C)
PIVOT PINS LUBE FITTINGS
(MIL-PRF-10924)
(81349)
Grease (GAA)
As required
All temperatures
TM 5-3805-274-13&P
0049
0049-1


Back to Top