TM-5-3805-274-13-P
DUMP TRUCK BODY M917
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
AUGUST 2013
TM-5-3805-274-13-P - Page 83 of 364
FIELD MAINTENANCE
SERVICE UPON RECEIPT
INITIAL SETUP:
References
WP 0004
WP 0014
WP 0019
WP 0022
WP 0030
WP 0042
References - Continued
WP 0044
WP 0048
WP 0049
DA PAM 750-8
DD Form 361
TM 9-2320-273-10
SERVICE UPON RECEIPT OF MATERIEL
NOTE
The operator will assist when performing service upon receipt
inspection.
This work package contains the procedures for inspecting and servicing the M917 Dump Truck Body upon
receipt to ensure its readiness for service. No special tools or equipment are required to perform these
procedures. Only visual inspections are required. However, if servicing required you may need a repair part.
See the (RPSTL) work package or (PMCS) lubrication work package in this manual.
Upon receipt of a new, used, or reconditioned M917 Dump Truck, perform the following steps to determine if
the M917 Dump Truck has been properly prepared for service.
CHECKING UNPACKED EQUIPMENT
Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the
damage on DD Form 361, Transportation Discrepancy Report.
Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with applicable service instructions (e.g., for Army instructions, see DA PAM 750-8).
Check to see whether the equipment has been modified.
INSTALLATION INSTRUCTIONS
Perform Preventive Maintenance Checks and Services (PMCS) WP 0019 and Lubrication Instructions
WP 0049 for the M917 Dump Truck Body.
Dump Body
1. Check dump bed and cab protector for structural damage such as broken weld seams, loose supports,
large dents, etc. If this type damage exists, refer to WP 0048.
2. Inspect tailgate locking mechanism. Pull release lever all the way forward and down. Locking jaws
should release so tailgate can swing out at the bottom. Release lever should operate freely. Ensure
tailgate is closed and raise release lever to engage locking jaws. If tailgate does not operate properly,
make repairs as directed in WP 0030.
Electrical System
1. Check operation of marker lights. Pull out headlight switch knob on instrument panel in
cab (TM 9-2320-273-10) and check that all marker lights are on. If lights are not on, refer to
troubleshooting WP 0014. Individual lights can be checked for defective lamps by replacing lens and
lamp assembly, refer to WP 0022.
2. Inspect wiring to ensure proper connection to vehicle chassis system.
TM 5-3805-274-13&P
0017
0017-1
Back to Top
