TM-5-3895-371-10
BITUMINOUS DISTRIBUTOR M918, MODEL D-63
TECHNICAL MANUAL; OPERATION INSTRUCTIONS
OCTOBER 1979
TM-5-3895-371-10 - Page 82 of 103
TM 5-3895-371-10
c.
Cleaning, Inspection, and Repair.
(1)
Clean all parts in an approved cleaning solvent. Dry thoroughly with clean, dry, compressed air
(2)
Inspect the cap for cracks, breaks, damaged threads, corrosion, distortion, or other damage. Inspect the
strainer for bends, breaks, tears, cracks, corrosion, or other damage.
(3)
Straighten bends or dents on the strainer. Replace the gasket. Replace strainer, if damaged.
d.
Installation
(1)
Place strainer (1) in position inside the discharge header. Make sure the large end of strainer is properly
seated.
(2)
Install new gasket (2).
(3)
Install and tighten header end cap (3).
3-14.
Burner Valve Strainer (fig. 3-7).
a.
Removal.
(1)
Remove the cap (3), gasket (4), and strainer (2) assembly from the burner fuel valve (1).
b.
Cleaning, Inspection, and Repair.
(1)
Clean the strainer and cap assembly in an approved cleaning solvent. Dry thoroughly with clean, dry,
compressed air.
(2)
Inspect the strainer and cap assembly for damaged threads, bends, cracks, breaks, holes, or tears in the
strainer, corrosion, distortion, or other damage.
(3)
Straighten bends. Replace a damaged cap and strainer assembly. Replace the gasket (4).
c.
Installation
. Install the cap (3), gasket (4), and strainer (2) assembly into burner fuel valve (1) and tighten.
3-15.
Filling Line Strainer (fig. 3-8).
NOTE
Place intake valve lever (27, fig. 1-1) in UP position.
3-20
Back to Top
