TM-5-3895-371-10
BITUMINOUS DISTRIBUTOR M918, MODEL D-63
TECHNICAL MANUAL; OPERATION INSTRUCTIONS
OCTOBER 1979
TM-5-3895-371-10 - Page 84 of 103
TM 5-3895-371-10
a.
Removal.
(1) Loosen clamp screw (2) and lift clamp (3)
(2) Remove filling line cap (1)
(3) Remove strainer (5) from asphalt filler line (4)
b.
Cleaning, Inspection, and Repair.
(1) Clean the strainer in an approved cleaning solvent
(2) Dry thoroughly with clean, dry compressed air
(3) Inspect the strainer for bends, breaks, cracks, tears, corrosion, distortion, or other damage
(4) Straighten bends
(5) Replace a damaged strainer
c.
Installation.
(1) Place strainer (5) in position in asphalt filler line (4) making sure strainer is properly seated
(2) Install filling line cap (1)
(3) Lower clamp (3) into position and tighten clamp screw (2)
3-16. Hydraulic Filter (fig. 3-9).
The filter element must be replaced when the indicator shows 17 in. restriction or higher.
a.
Removal
(1) Unscrew center post (8) to remove the filter housing and internal parts from the head
(2) Remove O-ring (1) from the groove in the head
(3) Remove top seal (2) from the center post (8)
(4) Remove and discard the filter element (3)
(5) Remove bottom seal (2) from center post (8)
(6) Remove spring (4) and washer (5) from center post (8)
(7) Remove center post (8) from housing (6)
(8) Remove gasket (7) from center post (8)
3-22
Back to Top
