TM-5-3895-371-24-P
BITUMINOUS DISTRIBUTOR BODY M918, MODEL D-63
TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL WITH REPAIR PARTS AND SPECIAL TOOLS LIST
MARCH 1981
TM-5-3895-371-24-P - Page 78 of 330
TM 5-3895-371-24 & P
(2)
Remove capscrew (2) and nut (5).
(3)
Remove capscrew (14) and nut (12); then lift out cylinder (9).
(4)
Loosen locknut (6) and remove clevis (4); then remove locknut (6).
(5)
Remove elbows (10) and (7) and bushings (11) and (8).
b.
Installation of Bar Shifting Control Cylinder. (Refer to fig. 2-20.)
(1)
Position cylinder as shown.
(2)
Install capscrew (14) and nut (12).
(3)
Install locknut (6) and clevis (4).
(4)
Adjust length of clevis (4) to line up its mounting hole with hole in bracket (3); then in-
stall capscrew (2) and nut (5).
(5)
Tighten locknut (6) against clevis (4).
(6)
Connect air lines (15) and (1) to elbows (10) and (7).
c.
Removal of Bottom Bar On-Off Cylinder. (Refer to fig. 2-21.)
(1)
Disconnect air line from each fitting (9).
(2)
Remove two cotter pins (2); then remove pins (1) and (6).
(3)
Remove cylinder (4).
2-55
Back to Top
