TM-5-3895-372-10

CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F

TECHNICAL MANUAL; OPERATION INSTRUCTIONS

OCTOBER 1979

TM-5-3895-372-10 - Page 158 of 184

TM 5-3895-372-10

b. Cleaning. Clean centerpost and cannister In dry cleaning solvent and blow dry.

c. Installation

(1) Replace O-ring (2) on filter head (1).

(2) Replace centerpost gasket (9).

(3) Install centerpost (10) with gasket (9) in cannister (8).

(4) Install the following parts into the cannister and centerpost.

(a) Spring (7) (Small end toward filter element).

(b) Steel washer (6).

(c) New O-ring (5).

(d) New oil filter (4).

(e) New O-ring (3).

(5) Install cannister (8) with assembled parts to filter head (1).

(6) Torque centerpost to 18 Ib-ft (24 N•m).

(7)

Fill hydraulic oil tank (refer to LO 5-3895-372-12).

(8)

Start engine and engage PTO (refer to TM 9-2320-273-10).

(9)

Check for leaks.

(10)

Shut down engine and disengage PTO (refer to TM 9-2320-273-10).

(11)

Recheck hydraulic oil tank level Add oil if required.

3-17. Liquid Admix Strainer Service.

NOTE

The strainer screen for the hi-flow and low-flow systems are the same and are serviced in the

same manner

a. Remove.

(1)

Close solution gate valve (fig. 3-13).

(2)

Open draincock (4, fig. 3-27) and drain strainer.

(3)

Remove draincock (4).

3-72