TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 312 of 694
TM 5-3895-372-20
AGGREGATE SUPPLY SYSTEM.
7-9.
RUBBER GUIDES MAINTENANCE (Continued).
LOCATION/ITEM
ACTION
REMARKS
B.
INSTALLATION.
3.
New guides (4 and 7)
Set in place.
Push screws on
three guide retainers (6),
retainer through holes in bin
and thirteen bolts (3).
wall.
4.
Thirteen washers
Install but do not tighten.
(2) and nuts (1).
Adjust guides to touch belt lightly.
If they are too high sand and stone will fall out.
If they
are pressed down too hard,
guides and belt will be damaged.
C.
ADJUSTMENT.
5.
Sand bin wall.
Loosen thirteen nuts (1).
If you replaced a guide,
nuts
will already be loose.
6.
Five sand bin guides
a. Starting at one end,
tap
(4) and three guide
guides down.
retainers (6).
1.
Outer guide (4) rests on
vanner edge (5) of belt.
2.
Guide retainer (6) rests
on flat surface of belt.
b. Tighten nuts (1) as you work.
7.
Center divider.
Loosen thirteen nuts (1).
8.
Center guide (7).
a. Starting at one end,
tap guide
down.
Guide should rest on
belt surface.
b. Tighten nuts (1) as you work.
9.
Stone bin wall.
Loosen thirteen nuts (1).
10. Stone bin edge guide (4)
a. Starting at one end,
tap guides
and guide retainer (6).
down.
1.
Adjust outer guide (4) to
vanner edge (5).
2.
Adjust guide retainer (6)
to belt surface.
b. Tighten nuts (1) as you go.
7-20
Back to Top
