TM-5-3895-372-20
CONCRETE-MOBILE MIXER BODY M919, MODEL 8CM-24/F
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL
AUGUST 1980
TM-5-3895-372-20 - Page 362 of 694
TM 5-3895-372-20
AGGREGATE SUPPLY SYSTEM.
7-18.
SAND AND STONE CONTROLS MAINTENANCE (Continued).
LOCATION/ITEM
ACTION
REMARKS
A.
INSPECTION (Continued)
b.
Check for binding, sticking,
or grinding as universal joints
turn.
Before removing universal joints, check that collars and shafts are punch marked.
If thev
are not.
mark them for proper position at assembly.
B.
REMOVAL.
2.
Two pins (11).
Drive out and remove two wheels
(22) from shaft (13) and (27).
3.
Two set screws (6).
Unscrew and remove two pointers (21).
4.
Four screws (20), lock-
Remove.
washers (17), and nuts (16).
5.
Four screws (23), lock-
Unscrew and remove two plates (18),
washers (17), and nuts (16).
dial face (19), and dial face (24).
6.
Two screws (26), lock-
Unscrew and remove guide (15) by
washers (25), and nuts (16)
sliding from shafts (13) and (27).
7.
Two lock screws (12
Unscrew and remove; slide locks (14)
from shafts (13) and (27).
8.
Four pins (11).
Drive out and remove two universal
joints (10).
9.
Two setscrews (6)
Back out and remove two collars (8).
10.
Six screws (9), lock-
Unscrew and remove two angles (7)
washers (2), and nuts (1).
with two shims (3).
11.
Two setscrews (6).
Loosen and remove two gears (5)
from two shafts (4).
C.
REPAIR.
Refer to para 4-10 for
Repair service is limited to the
repair of universal joints.
universal joints.
All other con-
trol components are simply re-
placed if worn or damaged.
D.
INSTALLATION
.
12.
Two angles (7) and
Aline holes and secure with six screws
shims (3).
(9), lockwashers (2), and nuts (1).
7-70
Back to Top
