TM-5-3990-263-13-P

PALLET, ADAPTER, BRIDGE, M15

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

APRIL 2012

TM-5-3990-263-13-P - Page 292 of 728

CORRECTIVE ACTION - Continued

CAUTION

Electrical power must be shut OFF from circuit before continuity can be checked.

Failure to comply with this caution may result in damage to test equipment or

electrical system.

4.

Set multimeter to ohms position.

NOTE

•

A reading of infinity indicates an open circuit.

•

Terminals to test are same on connector J8A (LH) and connector J8B (RH).

Test terminals of connector on side that does not operate.

5.

Place negative (-) probe of multimeter on terminal C of digital controller wiring harness connector

J8A (LH) or J8B (RH) (Figure 6).

RH LINKING

HARNESS

CONNECTOR (J8B)

LH LINKING

HARNESS

CONNECTOR (J8A)

Figure 6.

Left (Connector J8A) and Right (Connector J8B) Remote Locations.

6.

Place positive (+) probe of multimeter on position 7 of main frame junction box (Figure 7). Check

multimeter for continuity.

Figure 7.

Main Frame Junction Box (Wiring Removed For Clarity).

TM 5-3990-263-13&P

0032

0032-6