TM-5-3990-263-13-P
PALLET, ADAPTER, BRIDGE, M15
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
APRIL 2012
TM-5-3990-263-13-P - Page 282 of 728
CORRECTIVE ACTION - Continued
THUMB
SCREWS
POSITION
2
POSITION
3
POSITION
4
P2
ACCESS
COVER
Figure 7.
Connector P2.
8.
Place negative (-) probe of multimeter on position 35 of digital controller wiring harness connector
J4 (Figure 6).
9.
Place positive (+) probe of multimeter on position 3 of digital controller wiring harness connector
P2 (Figure 7). Check multimeter for continuity.
10.
Place negative (-) probe of multimeter on position 33 of digital controller wiring harness connector
J4 (Figure 6).
11.
Place positive (+) probe of multimeter on position 4 of digital controller wiring harness connector
P2 (Figure 7). Check multimeter for continuity.
12.
Place negative (-) probe of multimeter on position 5 of digital controller wiring harness connector
J3 (Figure 6).
13.
Place positive (+) probe of multimeter on position 1 of WINCH OUT solenoid connector
(Figure 6). Check multimeter for continuity.
14.
Place negative (-) probe of multimeter on position 35 of digital controller wiring harness connector
J3 (Figure 6).
15.
Place positive (+) probe of multimeter on position 2 of WINCH OUT solenoid connector
(Figure 6). Check multimeter for continuity.
a.
If continuity is not present at one or all of the readings, repair or replace digital controller
wiring harness. (TM 9-2320-435-10 or TM 9-2320-425-10)
b.
If continuity is present for all of the readings, proceed to next Malfunction.
TM 5-3990-263-13&P
0031
0031-6
Back to Top
