TM-5-3990-263-13-P
PALLET, ADAPTER, BRIDGE, M15
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
APRIL 2012
TM-5-3990-263-13-P - Page 387 of 728
FIELD MAINTENANCE
CENTER ROLLER REPAIR
INITIAL SETUP:
Tools and Special Tools
Tool Kit, General Mechanics: Automotive
(WP
0078, Table 2, Item 2)
Materials/Parts
Lockwasher (WP
0082, Table 1, Item 50) Qty:
1
Spring Pin (WP
0082, Table 1, Item 27) Qty:
4
References
Parts Manual (WP
0073, Figure 4)
Equipment Condition
Center roller hydraulic cylinders and hoses
removed. (WP
0060)
REMOVAL
1.
Remove screw (Figure 1, Item 1), lockwasher (Figure 1, Item 2), straight-headed pin (Figure 1, Item 3), center
roller assembly (Figure 1, Item 4), and two thrust washers (Figure 1, Item 5) from center roller carriage (Figure
1, Item 6). Discard lockwasher.
10
11
8
12
13
10
2
5
3
1
7
7
9
9
5
6
4
Figure 1.
Center Roller Removal.
2.
Remove two spring pins (Figure 1, Item 7) from two front strap pins (Figure 1, Item 8). Remove two strap pins
(Figure 1, Item 8) and pull straps (Figure 1, Item 9) from center roller carriage (Figure 1, Item 6). Remove center
roller carriage (Figure 1, Item 6) from the BAP. Discard spring pins.
3.
Remove two spring pins (Figure 1, Item 10) from two rear strap pins (Figure 1, Item 11). Remove two strap
pins (Figure 1, Item 11) and pull straps (Figure 1, Item 9) from rear cylinder carriage (Figure 1, Item 12). Remove
rear cylinder carriage (Figure 1, Item 12) from the BAP. Discard spring pins.
TM 5-3990-263-13&P
0044
0044-1
Back to Top
