TM-5-3990-263-13-P
PALLET, ADAPTER, BRIDGE, M15
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
APRIL 2012
TM-5-3990-263-13-P - Page 550 of 728
INSPECTION
Refer to General Maintenance Instructions (WP
0038) for general inspection instructions.
END OF TASK
ASSEMBLY
NOTE
•
Install circuit board as noted prior to disassembly.
•
Install wires as noted prior to disassembly.
1.
Install circuit board (Figure 6, Item 48) in base (Figure 6, Item 5) with two screws (Figure 6, Item 60).
47
53
60
48
49
51
50
52
5
56
58
57
59
55
54
Figure 6.
Remote Control Unit Assembly.
NOTE
Install cable ties as required.
2.
Solder all wires (Figure 6, Item 59) on connector J9 (Figure 6, Item 57).
NOTE
Install connector in base with notch facing up.
3.
Install gasket (Figure 6, Item 58) and connector J9 (Figure 6, Item 57) in base (Figure 6, Item 5) with four
screws (Figure 6, Item 56), lockwashers (Figure 6, Item 55), and nuts (Figure 6, Item 54).
4.
Install spade connector (Figure 6, Item 52), spade connector (Figure 6, Item 51), spade connector (Figure 6,
Item 50), and spade connector (Figure 6, Item 49) on relay (Figure 6, Item 53).
5.
Install connector (Figure 6, Item 47) on circuit board (Figure 6, Item 48).
TM 5-3990-263-13&P
0067
0067-6
Back to Top
