TM 5-4210-249-13&P-1
0111-9
DRAFT
0111
TFFT02663
Step 9.
Open pump operator’s panel housing (WP 0325).
Check No. 3 passenger side
discharge valve control wire harness at NO. 3 PASSENGER SIDE DISCHARGE valve
control and No. 3 passenger side discharge valve motor for loose connections.
If No. 3 passenger side discharge valve control wire harness connectors are
loose, reconnect loose connectors (WP 0453).
NOTE
•
Engine may have to be running to provide enough power to operate valve control.
Valve
will operate with less voltage, but only yellow indicator light will register on valve control.
•
Do not engage water pump engine during this procedure.
Valve operations can be
checked without water pump operation.
•
Valve motor operation can be checked by noting vibration of valve assembly, or by
observing rotation of 7/16 in. hex at end of valve drive assembly worm gearshaft.
•
Do not remove cap from NO. 3 PASSENGER SIDE DISCHARGE.
Water may be
released from system when valve is operated.
Step 10.
While an assistant pushes pump operator’s panel NO. 3 PASSENGER SIDE
DISCHARGE valve control OPEN and CLOSE buttons (WP 0004), check if NO. 3
PASSENGER SIDE DISCHARGE valve control yellow indicator illuminates and No. 3
passenger side discharge valve motor operates.
If indicator illuminates and valve motor operates, replace No. 3 passenger
side discharge valve drive assembly (WP 0388).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION