0018
TM 5-5420-202-10
LAUNCHING BRIDGE
WARNING
Exceeding slope limits (Figure 1) during bridge launch may cause the vehicle to become
unstable and overturn or roll. DO NOT exceed uphill, downhill, or side slope limits when
launching the bridge. Failure to comply may result in personnel injury or death, or
equipment damage.
CAUTION
Far-shore area must be in line with near-shore area and must be 60 ft (18.3 m) or less from
near-shore. Area where bridge will rest must be free of trees, boulders, and other objects
that will not provide good support. Care in selecting launching site will reduce or eliminate
damage to bridge or vehicle and make it easier to disconnect vehicle from bridge.
Figure 1.
Maximum Slope for Bridge Launching.
NOTE
In choosing a launching site, consider which end of the bridge will be used for retrieval. This
end of the bridge should provide ground support if possible.
1. Start engine and move vehicle into desired position in line with selected site. Refer to WP 0015.
2. Press and hold brake pedal (Figure 2, Item 1).
3. Move transmission shift lever (Figure 2, Item 3) to N (Neutral).
0018-2