TM 5-5420-202-10
0040
SYMPTOM
MALFUNCTION
CORRECTIVE ACTION
NOTE
Indicator windows that measure
restriction in degrees are not reset
until f lter element has been cleaned
or replaced.
STEP 7. Check engine air intakes inside crew
compartment or through top deck grille doors for
obstruction (WP 0029).
STEP 8. Remove any foreign material obstructing air
intakes and start engine (WP 0015).
STEP 9. If engine does not run properly, notify f eld
maintenance.
STEP 10. For vehicles without air restriction
indicators, notify f eld maintenance.
Powerplant warning light
comes on.
POWERPLANT
WARNING LIGHT
COMES ON WHILE
ENGINE IS ABOVE
750 TO 800 RPM.
CAUTION
Check ENGINE and TRANSMISSION
oil pressure and temperature
indicators (gauges). Stop engine
if ENGINE or TRANSMISSION
indicators show in red (WP 0015).
Engine or transmission may overheat
and damage to both components may
occur. Failure to comply may result in
equipment damage.
STEP 1. Check right and left top deck grille doors to
see if obstruction is blocking airf ow.
STEP 2. Check engine and transmission oil cooler
screens for obstruction by dirt, leaves, or other foreign
material (Figure 1). If obstruction is found, notify f eld
maintenance.
Figure 1.
Oil Cooler Screen Location.
0040-5
Table 1.
Engine - Continued.