TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 430 of 734

TM 5-5420-202-20-2

PRIMARY FUEL FILTER REPLACEMENT (Sheet 4 of 4)

10.

11.

12.

13.

14.

15.

16.

17.

Using adjustable wrench, unscrew bleed cap (J) until it can be opened or closed using fingers.

Leave valve open.

Using another technician, set FUEL PUMPS

switch (K) on master control panel in driver’s

compartment to ON.

Set MASTER BATTERY switch (L) to ON

and observe air release (bubbles) from bleed

valve (J).

Set MASTER BATTERY switch (L) to OFF and, after about 1 minute, repeat step 12.

Repeat steps 12 and 13 until a steady flow

of fuel comes out of bleed valve (J), then

close bleed valve (J) and set MASTER

BATTERY switch to OFF.

Using adjustable wrench, tighten bleed valve (J) enough so it cannot be opened with the

fingers.

Disconnect ground hop kit (page 5-40).

Install powerplant (page 5-14).

End of Task

7-195