TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 1028 of 1060

TM 5-5420-202-20-3

FENDER AND SHIELD (REAR) REPLACEMENT (Sheet 1 of 7)

PROCEDURE INDEX

PROCEDURE

PAGE

Removal

16-69

Installation

16-72

TOOLS:

:

1-in. socket with 1/2 in. drive

9/16 in. socket with 112 in. drive

Ratchet with 1/2 in. drive

7/16 in. socket with 1/2 in. drive

9/16 in. combination box and open end wrench

7/16 in. combination box and open end wrench

5 in. extension with 1/2 in. drive

1/2 in. combination box and open end wrench

Torque wrench with 1/2 in. drive (0-175 lb-ft)

Handle, socket wrench, hinged, 1/2 in. drive

SUPPLIES: Lockwasher (9 required)

Locknuts (8 required)

REMOVAL

NOTE

Left rear fender and shield shown.

Right rear removal is

similar.

1.

Using 9/16 inch socket on five screws (A) and 9/16 inch wrench on nuts (B) remove five

screws (A), washers (C), lockwashers (D), and nuts (B) holding fender (E) to angle (F).

Go on to Sheet 2

16-69