TM 5-5420-202 -20-3
MASTER CONTROL PANEL REPAIR (Sheet 49 of 73)
Personnel Heater Wiring Harness Replacement (Sheet 2 of 6)
3.
4 .
Using flat-tip screwdriver on screws (F)
and wrench on nuts (H), remove four screws
(F), lockwashers (G), and nuts (H) securing
connector (J) to panel (E).
Remove conector (J) from panel
position aside.
NOTE
It may be necessary to disconnect
other circuitry not related to the task
at hand, for access. Make note of all
circuits disconnected so that at
installation all circuits are properly
connected.
Go on to Sheet 3
10-86
TA249027