TM 5-5420-202-20-3
MASTER CONTROL PANEL REPAIR (Sheet 39 of 73)
Circuit Breaker Replacement (Sheet 7 of 7)
REMOVAL; CIRCUIT BREAKER (G):
1.
Using fingers, disconnect two electrical connectors from rear of circuit breaker (A) by
pulling out.
2.
Using cross-tip screwdriver, remove two screws (B) and lockwashers (C) securing circuit
breaker (A) to panel.
3.
Remove circuit breaker (A).
INSTALLATION; CIRCUIT BREAKER (G):
1.
2.
3.
4.
5.
Place circuit breaker (A) in position on
panel.
Using cross-tip screwdriver, install two
screws (B) and lockwashers (C) securing
circuit breaker (A) to panel.
Apply silicone compound to two male
electrical connectors for circuit breaker
(A).
Using fingers,
connect
two
electrical
connectors in rear of circuit breaker (A).
Install panel in vehicle (page 10-36).
End of Task
10-76
TA249017