TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 287 of 1060

TM 5-5420-202-20-3

BATTERY JUMPER CABLE ASSEMBLY REPLACEMENT (Sheet 4 of 6)

CLEANING AND INSPECTION:

1.

Inspect contact points on positive battery terminal lugs and inspect battery jumper

cable assembly for rust and corrosion.

2.

Using steel wool, clean contact points until they shine.

INSTALLATION:

1.

2.

3.

4.

Place bolt (A) and battery

battery terminal lugs (C).

Holding bolt (A) with one

jumper cable assembly (B) to positive battery terminal lugs (C).

jumper cable assembly contact point (B) in position on positive

wrench, use other wrench to install nut (D) securing battery

Install both ends of battery jumper cable assembly (B) on two positive battery terminal lugs

(C).

Apply a light coat of grease on two positive battey terminal lugs (C) to prevent corrosion.

Go on to Sheet 5

TA249189

10-248