TM-9-2320-209-10-1

2 1/2-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; OPERATION, INSTALLATION AND REFERENCE DATA; OPERATOR LEVEL

SEPTEMBER 1980

  TM-9-2320-209-10-1 - Page 460 of 549

TM 9-2320-209-10-1
e .
Parking.
(1) Park truck in a sheltered area out of the wind, where possible. If no shelter is
available, park truck so that it does not face into the wind.
(2) Park truck on high dry ground, if possible.
If high dry ground is not available,
spread out planks or brush and put wheel chocks in place, if necessary.
(3) Park truck on level ground so that body does not twist.
(4) Place all control lever in neutral position to stop freezing in gear due to water
condensation.
(5) In areas where temperatures reach -50°F or colder, put an extra 20 pounds of
air (above normal) in tires for long standby periods or overnight. (Refer to volume 2,
chapter 1, table 1-1.)
(6) Let the extra air out of tires before starting normal operations. Do not lower
pressure when tires are hot.
(7) Turn power plant heater on. (Refer to para 4-17e.)
(8) If truck does not have an arctic kit, tell organizational maintenance to take
batteries out. Store batteries in a warm place.
(9) The cooling system must be serviced and protected for temperatures below 32 °F.
Refer to TM 9-750-651 and TM 9-207 for special procedures.
(10) If no approved antifreeze solution is available, tell organizational maintenance
to drain radiator and block.
4-406


Back to Top