TM-9-2320-209-10-1

2 1/2-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; OPERATION, INSTALLATION AND REFERENCE DATA; OPERATOR LEVEL

SEPTEMBER 1980

  TM-9-2320-209-10-1 - Page 84 of 549

TM 9-2320 -209-10-1
a.
Before Engine Startup.
FRAME 1
1.
Pull handbrake lever (1) up to position.
NOTE
The handbrake must click into place when handbrake lever (1)
is being pulled up. If you do not hear a click adjust handbrake
as given in steps 2 through 5.
2.
Push handbrake lever (1) forward to off position.
3.
If the handbrake is loose (not enough tension) turn knob (2) to the right one
turns. If the handbrake is tight (too much tension) turn knob (2) to the left
two turns.
4.
Pull handbrake lever (1) up again.
or two
one or
5.
If handbrake clicks into place it is properly adjusted. If click is not heard, do
steps 2, 3 and 4 again until handbrake clicks into place.
6.
If handbrake cannot be properly adjusted tell organizational maintenance.
7.
Set FRONT TRANSMISSION gearshift lever (3) to N position.
GO TO FRAME 2
4-30


Back to Top