TM-9-2320-209-20-3-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 3 OF 4

MAY 1981

TM-9-2320-209-20-3-3 - Page 412 of 548

TM 9-2320-209-20-3-3

18-75. VAN DOOR ASSEMBLY REMOVAL AND REPLACEMENT (TRUCKS M109A2,

M109A3, M185A2, AND M185A3).

TOOLS:

NOTE

This task is the same for the right and left rear

van door assemblies. This task is shown for

the right rear van door.

3/8-inch drive socket wrench set Flat-tip screwdriver

1/2-inch wrench

1/2-inch socket wrench

Hoist sling

6-inch extension

Hoist equipment, 2-ton capacity 10-foot stepladder

SUPPLIES:

None

PERSONNEL: One

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

Preliminary Procedure. If left rear door is being taken off, remove ladder.

Refer to TM 9-2320-209-10.

b.

Removal.

1.

Working inside truck, using screwdriver, unscrew and take out two screws

(1). Pull door check (2) away from door (3). Open door partway.

GO TO FRAME 2

18-397