TM-9-2320-209-34-2-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 3

MAY 1981

TM-9-2320-209-34-2-2 - Page 781 of 899

TM 9-2320-209-34-2-2

17-65. DUMP TRUCK SUBFRAME REMOVAL AND REPLACEMENT.

TOOLS:

No special tools required

SUPPLIES: None

PERSONNEL:

Two

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

a.

Preliminary Procedures.

(1) Remove dump body. Refer to para 17-68.

(2) Remove hydraulic hoist control linkage. Refer to Hydraulic Hoist

Control Linkage Removal, Replacement,

and Adjustment TM 9-2320-209-20.

(3) Remove hydraulic hoist pump drive shaft. Refer to Hydraulic Hoist

Pump Drive Shaft Removal, Repair, and Replacement, TM 9-2320-209-20.

b. Removal.

FRAME 1

1.

2.

3.

Take out two screws with self-locking nuts (1). Take off fender with

bracket (2).

Take out screw with self-locking nut (3).

Do steps 1 and 2 again for other rear fender.

GO TO FRAME 2

17-763