TM-9-2320-209-34-2-2
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 3
MAY 1981
TM-9-2320-209-34-2-2 - Page 96 of 899
TM 9-2320-209-34-2-2
Section III.
FENDERS, RUNNING BOARDS, AND WINDSHIELD ASSEMBLY
17-7.
FRONT FENDER REMOVAL, REPAIR, AND REPLACEMENT.
NOTE
This task is the same for left and right front
fenders except as noted.
TOOLS:
No special tools required
SUPPLIES:
Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680
Clean rags
PERSONNEL:
T
W
o
EQUIPMENT CONDITION:
Truck parked, engine off, handbrake set.
a.
stack.
Preliminary Procedures.
(1) Open hood.
Refer to TM 9-2320-209-10.
(2) If working on right fender of truck with exhaust stack, remove exhaust
Refer to TM 9-2320-209-20.
(3) If working on left fender of truck and truck has personnel hot water
heater, remove personnel hot water heater, Refer to TM 9-2320–209-20.
(4) If working on left fender, and truck has vehicular compartment heater,
remove vehicular compartment heater and exhaust tube. Refer to TM 9–2320-209-20.
(5) If working on right fender,
remove air cleaner intake hood. Refer to
TM 9-2320-209-20.
(6) If working on right fender and vehicle is equipped with an engine com-
partment heater, remove clamp holding heater control wire and push wire out of way.
Refer to Hot Water Personnel Heater Blower Motor Repair, TM 9-2320-209-20.
(7) If working on right fender, remove hood right side panel. If working
on left fender, remove hood left side panel. Refer to TM 9-2320-209-10.
17-79
Back to Top
