TM-9-2320-209-34-2-3
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3
MAY 1981
TM-9-2320-209-34-2-3 - Page 12 of 592
TM 9-2320-209-34-2-3
CHAPTER 18
WINCH, HOIST, AND POWER
TAKEOFF ASSEMBLIES GROUP MAINTENANCE
Section I. SCOPE
18-1. EQUIPMENT ITEMS COVERED.
This chapter gives equipment maintenance
procedures for the winch and hoist assemblies, and power takeoff assembly for which
there are authorized corrective maintenance tasks at the direct and general support
maintenance levels.
18-2. EQUIPMENT ITEMS NOT COVERED.
All equipment items for which corrective
maintenance is authorized at the direct and general support maintenance levels are
covered in this chapter.
Section II.
WINCH AND HOIST ASSEMBLIES
18-3. FRONT WINCH REPAIR.
TOOLS:
No special tools required
SUPPLIES:
Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680
Clean rags
Gearcase cover gasket
Bearing cap gasket
Sliding clutch key (2)
Brake case gasket
Preformed packing
Brake case cover gasket
PERSONNEL: T
W O
EQUIPMENT CONDITION:
Truck parked, engine off, handbrake set.
a.
Preliminary Procedures.
(1) Remove front winch.
Refer to TM 9-2320-209-20.
(2) Drain front winch. Refer to LO 9-2320-209-12/1.
18-1
Back to Top
