TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 180 of 592

TM 9-2320-209-34-2-3

18-7. HYDRAULIC HOIST REMOVAL, REPAIR, AND REPLACEMENT (TRUCK M342A2).

TOOLS:

No special tools required

SUPPLIES:

Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

Artillery and automotive grease, type GAA, MIL-G-10924

PERSONNEL: Two

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

a. Preliminary Procedure.

Start engine and raise dump body. Refer to

TM9-2320-209-10.

b. Removal.

FRAME 1

1.

Take out lubrication fitting (1).

2.

Take out screw (2) and nut (3).

3.

Place wood block (4) under ends of two hoist cylinders (5) as shown.

4.

Drive out pin (6).

5.

Do steps 1, 2, and 4 again for other side of dump body.

6.

Start engine and place dump body control in down position to pull back hoist

assembly (7). Refer to TM 9-2320-209-10.

7.

Slide off roller arm assemblies (8 and 9).

GO TO FRAME 2

18-169