TM-9-2320-260-10
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 1985
TM-9-2320-260-10 - Page 177 of 411
Change 4
2-101
TM 9-2320-260-10
C A U T I O N
Do not force clutch drum lever to free clutch. Engage power takeoff in
forward or reverse gear, as required, and slip engine clutch slightly.
(3)
Disengage drum jaw clutch by moving drum clutch lever (18) as far as it will go toward the
winch. Swing hinged plate down to lock drum clutch lever (18).
(4)
Lock drum in place with drum lock knob (17) by pulling knob out, rotating it 90 degrees,
and releasing. If necessary, rotate drum by hand to allow drum lock plunger to engage hole in
winding frame.
(5)
On winches with level wind, release lock by pulling lock knob (15) out. Rotate it 90
degrees and release. If necessary, move level wind (16) by hand to allow lock plunger to engage
hole n winding frame.
(6)
Swing hinged holding plate on headboard down and around winch control lever (3) to
secure lever in place.
(7)
Service snatch block and other equipment used in winching and stow.
(8)
to replace winch shear pin; refer to paragraph 3-17.
i. Preparing Winch for Travel.
(1)
On winches without level wind,
position cable chain (12) under and over the
left frame extension (9), then across the top of
the bumper (11), so the chain hook (13) can be
attached to the right lifting shackle (14).
Remove left lifting shackle (10) and place it
over chain, then reinstall lifting shackle (10).
(2)
On winches with level wind,pull cable
chain (12) up through the space between the
bumper (11) and winch on the left side. Wind
cable chain around back of the level winding
frame, then across the front so the chain hook
(13) can be attached to the left side of the level
winding frame.
Back to Top
