TM-9-2320-260-10

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; OPERATOR'S MANUAL

JUNE 1985

TM-9-2320-260-10 - Page 227 of 411

Change 4

2-151

TM 9-2320-260-10

N O T E

Complete the following procedures for each of the four outriggers.

• Steps c through h require two crewmembers.

• Delete steps c through h to raise vehicle for towing.

(c)

Remove retainer clips from L-shaped pins (3) and remove pins (3).

(d)

Grasp outrigger base (5) and pull out all the way.

(e)

Swing outrigger base (5) down to the ground.

(f)

Install L-shaped pin (3) in frame (7) and secure with retainer clips.

(g)

Insert outrigger handle (6) into hole in outrigger collar (4) and turn collar (4) until base

(5) encounters pressure against the ground. Make sure outrigger is straight up and down with base.

(h)

Start engine (refer to paragraphs 2-12 and 2-13).

N O T E

Brakes are now locked in place and remain locked until brake pedal is

depressed and released again.

(i)

Depress clutch pedal (8) all the

way and place transfer selector lever (11) in

“N” (neutral) position.

(l)

Press electric brake lock button

(15) and hold. Depress service brake pedal (9)

down all the way and release. Release brake

lock switch button (15).

(j)

Place gearshift lever (10) in “4”

(fourth) gear (14).

(k)

Move power divider control lever

lock (13) to unlocked position and push power

divider control lever (12) down to engaged

position. Release clutch pedal (8) slowly.