TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 343 of 1337
TM 9-2320-260-20
3-5. ENGINE OIL FILTER AND HOUSING MAINTENANCE
THIS TASK COVERS:
a. Oil Drainage
d. Waning and Inspection
b. Filter Removal
e. Oil Filter Housing Assembly
c. Oil Filter Housing Disassembly
f. Filter Installation
INITIAL SETUP
APPLICABLE MODELS
All
MATERIALS/PARTS
Oil filter replacement kit, AR 51480
Copper gasket
Gasket
Seal
Drycleaning solvent (Appendix C, Item 29)
Lubricating oil (Appendix C, Item 20)
Rags (Appendix C, Item 22)
REFERENCES (TM)
●
Parking brake set (TM 9-2320-260-10).
• Hood raised and secured (TM 9-2320-260-10).
GENERAL SAFETY INSTRUCTIONS
●
Do not drain oil when engine is hot.
●
Keep fire extinguisher nearby when using
drycleaning solvent.
LO 9-2320-260-12
TM 9-2320-260-10
TM 9-2320-260-20P
I
a. Oil Drainage
WARNING
Do not drain oil when engine is hot. Injury to personnel may result.
NOTE
Have drainage container ready to catch oil.
1. Remove drainplug (10) and gasket (11) from oil pan (12). Allow oil to drain completely. Discard
gasket (11).
2. Install new gasket (11) and drainplug (10) in oil pan (12). Tighten drainplug (10) 60-70 lb-ft
(81-95 N•m).
NOTE
Have drainage container ready to catch oil.
3. Remove drainplug (4) from oil filter housing (1). Allow oil to drain completely.
4. Install drainplug (4) in oil filter housing (1). Tighten drainplug (4) 25-35 lb-ft (34-47 N•m).
b. Filter Removal
I
1. Loosen center bolt (3) and remove oil filter housing (1) from oil pump (15).
2. Remove oil filter element (13) and seal (14) from oil filter housing (l). Discard oil filter element (13)
and seal (14).
c. Oil Filter Housing Disassembly
1. Remove clip pin (9), filter element support (8), seal (7), washer (6), and spring (5) from center
bolt (3). Discard seal (7).
2. Remove center bolt (3) and copper gasket (2) from oil filter housing (l). Discard copper gasket (2).
3-6
Back to Top
