TM-9-2320-260-20

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

APRIL 1995

TM-9-2320-260-20 - Page 572 of 1337

TM 9-2320-260-20

I

6-4. TRANSFER CASE SHIFT LEVER AND CONTROL LINKAGE MAINTENANCE

(Contd)

7.

8.

9.

10.

11.

Position shaft (7) in bracket (3) and install retainer (2) on bracket (3) with screw (4) and new

locknut (l). Turn shaft (7) as necessary to engage vertical slot of shaft (7) with retainer (2).

Install bracket (3) and shaft (7) on frame crossmember (26) with two screws (27) and new

locknuts (5). Ensure free end of shaft (7) points to left side of vehicle.

Install transfer control lever (6), short end down, on left end of shaft (7) with washer (8) and new

cotter pin (9). Lock cotter pin (9).

Loosen jamnut (13) on adjusting rod (11) and set clevis holes 8.75 in. (22.3 cm) apart. Do not tighten

jamnut (13).

Install adiusting rod (11) on relay lever (20) and lower hole on transfer control lever (6) with two

clevis pin; (10) ;nd new cotter pins (12). Lock cotter pins (12) at transfer control lever (6). Do not

lock cotter pin (12) at relay lever (20) until adjustments in task c. are completed.

6-5