TM 9-2320-260-20
I
8-14. AIR-HYDRAULIC CYLINDER REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
All
MATERIALS/PARTS
Twelve locknuts
EQUIPMENT CONDITION
●
Parking brake set (TM 9-2320-260-10).
●
Air reservoirs drained (TM 9-2320-260-10).
GENERAL SAFETY INSTRUCTIONS
Two seals
Do not disconnect air lines before draining air
Antiseize tape (Appendix C, Item 30)
reservoirs.
REFERENCES (TM)
TM 9-2320-260-10
TM 9-2320-260-20P
I
a. Removal
I
1. Remove four locknuts (17), screws (20), washers (19), and shield (16) from two brackets (18).
Discard locknuts (17).
WARNING
Do not disconnect air lines before draining air reservoir. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
2. Disconnect leads (2) from stoplight pressure switch (3).
NOTE
Tag all air lines for installation.
3. Disconnect four air lines (4), (5), (9), and (22) from elbows (7), (6), (8), and (21).
4. Disconnect air line (1) from air-hydraulic cylinder (15).
5. Disconnect air line (10) from air-hydraulic cylinder (15).
6. Remove four locknuts (11), screws ( 14), washers (13), and air-hydraulic cylinder (15) from
brackets (12). Discard locknuts (11).
8-26