TM-9-2320-260-20

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

APRIL 1995

  TM-9-2320-260-20 - Page 859 of 1337

TM 9-2320-260-20
I
12-12. DUMP BODY TAlLGATE REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
lNlTIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
M817
MATERIALS/PARTS
Four locknuts
TM 9-2320-260-10
TM 9-2320-260-20P
EQUIPMENT CONDITION
PERSONNEL REQUIRED
Parking brake set (TM 9-2320-260-10).
Two
GENERAL SAFETY INSTRUCTIONS
All personnel must stand clear during lifting
operations.
1. Install chain on tailgate (4).
2. Install lifting device on chain.
3. Position tailgate control lever to open position (TM 9-2320-260-10).
4. Remove slack from chain and remove two pins (2) from dump body (l).
WARNIN G
All personnel must stand clear during lifting operations. A swing-
ing or shifting load may cause injury or death to personnel.
5. Remove tailgate (4) from dump body (1) and lower tailgate (4) onto supports.
6. Remove lifting device from chain.
7. Remove chain from tailgate (4)
8. Remove four locknuts (7), two plates (6), four screws (5), and two steps (3) from tailgate (4). Discard
locknuts (7).
1. Install two steps (3) and plates (6) on tailgate (4) with four screws (5) and new locknuts (7).
2. Install chain on tailgate (4).
3. Install lifting device on chain.
All personnel must stand clear during lifting operations. A swing-
ing or shifting load may cause injury or death to personnel.
4. Raise tailgate (4) and position tailgate (4) on dump body (1).
5. Install two pins (2) on dump body (1).
6. Position tailgate control lever to locked position (TM 9-2320-260-10).
7. Remove lifting device from chain.
8. Remove chain from tailgate (4).
12-22


Back to Top