TM-9-2320-260-34-1

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME 1 OF 2

JULY 1994

TM-9-2320-260-34-1 - Page 618 of 657

TM 9-2320-260-34-1

11-3. AIR COMPRESSOR REPLACEMENT (Contd)

b. Installation

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

Install coupling drive (2) on accessory drive (1).

NOTE

l

Ensure oil passage holes in new gasket are open. Aline holes

with oil passage prior to installation.

l

Male threads must be wrapped with antiseize tape before

installation.

Bar engine to “1-6” index mark (3). Set air compressor timing mark (3) between nine and ten o’clock,

as viewed from accessory drive coupling end.

Install new gasket (7) and air compressor (17) on accessory drive (1) with two screw-assembled

washers (21).

Install bracket (26) on cylinder block (6) with two washers (27), and screws (28).

Install washer (25) and screw (24) on bracket (26) and air compressor (17).

Install two washers (22), screws (23), washers (20), new lockwashers (19), and nuts (18) on air

compressor (17) and accessory drive (1).

Install bracket (5) on cylinder black (6) with four screw-assembled washers (4).

Install hose (16) on air compressor (17) and tube (15) with two clamps (14).

Connect air outlet tube (11) on elbow (13) and tighten nut (12).

Connect air governor tube (10) on elbow (8) and

tighten nut (9).

11-6