TM-9-2320-260-34-2
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME 2 OF 2
JULY 1994
TM-9-2320-260-34-2 - Page 319 of 863
15-69. CIRCUIT BREAKER HARNESS AND CIRCUIT BREAKER REPLACEMENT
THIS TASK COVERS:
a. Circuit Breaker Harness Removal
c. Circuit Breaker Removal
b. Circuit Breaker Harness Installation
d. Circuit Breaker Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
M820, M820A1, M820A2
TM 9-2320-260-10
TEST EQUIPMENT
TM 9-2320-260-20
TM 9-2320-260-34P-2
Multimeter (Appendix B, Item 115)
EQUIPMENT CONDITION
TOOLS
.
●
General mechanic’s tool kit
(Appendix B, Item 1)
Tool kit, electrical (Appendix B, Item 106)
External power source disconnected
(TM 9-2320-260-10).
Battery ground cable disconnected
(TM 9-2320-260-20).
MATERIALS/PARTS
Locknut (Appendix D, Item 167)
Locknut (Appendix D, Item 191)
Lockwasher (Appendix D, Item 224)
a. Circuit Breaker Harness Removal
1.
Disconnect connector (2) from circuit breaker (1).
2. Remove two screws (4) and clamps (3) from van body ( 15).
3. Remove locknut (10), screw (13), and clamp (14) from spare tire carrier mounting bracket (5).
Discard locknut (10).
4. Remove locknut (6), screw (12), washer (11), circuit breaker harness (9), wire (8), and lockwasher (7)
from spare tire carrier mounting bracket (5). Discard locknut (6) and Iockwasher (7).
5. Remove circuit breaker harness (9) from van body (15).
b. Circuit Breaker Harness Installation
1.
Install new lockwasher (7), wire (8), and circuit breaker harness (9) on spare tire carrier mounting
bracket (5) with washer (11), screw (12), and new locknut (6).
2. Install clamp (14) on spare tire carrier mounting bracket (5) with screw (13) and new locknut (10).
3. Install two clamps (3) on van body (15) with two screws (4).
4. Connect connector (2) to circuit breaker ( 1).
c. Circuit Breaker Removal
1. Disconnect emergency lamp wiring harness (17) and circuit breaker harness (9) from circuit
breaker (1).
2. Remove two screws (16) and circuit breaker (1) from van body (15).
d. Circuit Breaker Installation
1. Install circuit breaker (1) on van body (15) with two screws
(16).
2. Connect emergency lamp wiring harness (17) and circuit breaker harness (9) to circuit breaker (1).
15-258
TM 9-2320-260-34-2
Back to Top
