TM-9-2320-273-34
TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1980
TM-9-2320-273-34 - Page 47 of 801
TM 9-2320-273-34
Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS
2-10. Introduction.
This section provides you with procedures for replacing major component parts of the
vehicle. Organizational level replacement procedures, described in TM 9-2320-273-20, are not repeated.
Following is a list of the
a.
Transmission
b.
Engine
c.
Transfer Case
d.
Front Axle
e.
Rear Tandem
f
Pusher Axle
2-11. Transmission.
a. Removal.
replacement procedures given in this section.
Axle
(1)
Disconnect transmission heater control wires. ( Refer to TM 9-2320-273-20). Remove e
x
-
haust pipe section. (Refer to TM 9-2320-273 -20.)
(2)
Drain transmission oil. (Refer to LO 9-2320-273-12.)
(3)
Disconnect applicable components from the PTO as follows:
(a)
Models M916, M917, M920. Remove hydraulic pump from PTO and tie it out
of the way. (Refer to TM 9-2320-273 -20.) It is not necessary to disconnect the
hydraulic lines.
(b)
Model M918. Remove prop shaft from PTO to hydraulic pump. (Refer to
TM 5-3895-371-24& P.)
(c)
Model M919. Remove prop shaft from PTO to lower PTO belts shaft. (Refer
to TM 5-3895-372-20.)
(4)
Disconnect transmission oil cooler tubes at transmission. (Refer to TM 9-2320-273-20).
(5)
Remove dipstick tube bracket capscrew (fig. 2-1).
2-31
Back to Top
