TM 9-2320 -279-20-1
Engine Maintenance Instructions (Cent)
3-3. ROCKER COVER AND GASKET REMOVALIINSTALLATION.
This task cokrers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
Models
Equipment Condition
All
TM or Para
Test Equ.iprnen t
TM 9-2320-279-10
None
Special lbol.s
Para 16-9
Para 4-4
None
Supplies
Oil lubricating% Item 33. Amendix C
Para 5-2
Condition Description
Shut off engine.
Engine cool.
Engine cover removed.
Air intake ducting removed.
(Left side only).
Exhaust pipe removed.
(Right side only).
-,
. .
Personnel Required
Special Environmental Conditions
MOS 63S, Heavy wheel vehicle mechanic
None
R?, ,ref~es
Gerwral
Safety Instructions
one
None
a.
Removal.
CAUTION
c)
1
P
3
Clean around rocker cover before
removing each cover from engine. This will
keep dust or dirt from entering cylinder
heads.
NOTE
There are two kinds of breather hoses.
Model A is a metal ho~e that uses a U-bolt
type clamp. Model B is a rubber hose and
uses a worm gear type clamp. If a Model A
hose must be replaced by a Model B hose,
clamp must be changed also.
(1)
Remove clamps (1) and hoses (2) from
breather housing (3).
TA1 82132
3-4
Change 2