TM 9-2320-279-20-1
Electrical System Maintenance Instructions (Cont).
7-33. IGNITION RELAY REMOVAL/INSTALLATION (CONT).
b.
NOTE
Tag and mark wires before disconnecting.
(2)
Remove two screws (3), ground wire (4), and ground wire (5).
(3)
Remove four screws (6). Disconnect three wires (7, 8, and 9) and ground wire (5).
(4)
Remove ignition relay (10).
(1)
(2)
Installation.
Connect three wires (1, 2, and 3) and
wire (4) with four screws (5). Tighten
screws.
Install ignition relay (6), ground
wire (7), and ground wire (4) with two
screws (8).
7-102