TM 9-2320-280-20-2
7-21. REAR DUAL SERVICE/PARKING BRAKE PAD MAINTENANCE
This task covers:
a. Removal
c. Installation
b. Cleaning and Inspection
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
• Wheels chocked and parking brake released
(TM 9-2320-280-10).
• Pioneer tool stowage rack removed
(TM 9-2320-280-10).
General Safety Instructions
Make sure brake pads are installed with linings
facing rotor.
7-48
Change 3
NOTE
The following procedure applies to vehicles with serial numbers
USBL, Eff, 44825 and above.
1.
Remove cotter pin (4), washer (5), and clevis pin (7) from parking brake clevis (6) and lever (3).
Discard cotter pin (4).
2.
Remove retaining ring (2) and disconnect parking brake cable (8) from caliper cable bracket (1).
Discard retaining ring (2)
CAUTION
Use tiedown strap to support caliper during removal to prevent
damage to brake line.
3.
Remove two capscrews (12), washers (13), and pull yoke (14) and caliper (15) away from rotor (10).
NOTE
Note positioning of brake pad surfaces for installation.
4.
Remove two brake pads (9) from adapter (11) and rotor (10).
a. Removal
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Hex wrench (Appendix D, Fig. D 115)
Open end wrench (Appendix D, Fig. D 116)
Special Tools
Crowfoot, 14 mm (Appendix B, Item 152)
Materials/Parts
Retaining ring (Appendix G, Item 231)
Cotter pin (Appendix G, Item 12)
Sealing compound (Appendix C, Item 45)
Grease (Appendix C, Item 22)
Tiedown strap (Appendix G, Item 312)