TM-9-2320-280-34
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
JANUARY 1996
TM-9-2320-280-34 - Page 106 of 1258
3-44.2
Change 1
3 - 2 1 . 1 .
ENGINE REPLACEMENT IN SHIPPING/STORAGE CONTA
I N E R
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix G, Item 1)
Special Tools
Engine lifting sling
(Appendix G, Item 22)
Materials/Parts
Eight lockwashers (Appendix E, Item 83)
Manual Refere n c e s
________________
TM 9-2320-280-24P
TM 9-2815-237-34
Personnel Required
One mechanic
One assistant
General Safety Instructions
Direct personnel to stand clear during hoisting
operation.
Maintenance Level
Direct support
TM 9-2320-280-34
a. Removal
1.
Press air-release button (1) located at center of breather valve (2) before opening engine container (5).
2.
Remove twenty-six nuts (19), washers (18), capscrews (16), and upper container (4) from lower
container (13).
3.
Position engine lifting sling on engine (6) and install on right cylinder head (23) with two capscrews (24).
4.
Install sling bracket on left cylinder head (20) with two capscrews (22). Tighten capscrews (22) and
install sling bracket to engine lifting sling with pin (21).
5.
Remove four capscrews (14), lockwashers (8), and washers (7) from two engine mounts (12). Discard
lockwashers (8).
6.
Remove four capscrews (9), lockwashers (8), and washers (7) from two rear engine mounts (11).
Discard lockwashers (8).
WARNING
Direct personnel to stand clear during hoisting operation. Failure
to do this may cause injury to personnel.
7.
Attach hoist to engine lifting sling and remove engine (6) from lower container (13).
8.
Prepare engine for assembly (TM 9-2815-237-34).
b. Installation
WARNING
Direct personnel to stand clear during hoisting operation. Failure
to do this may cause injury to personnel.
1.
Attach hoist to engine lifting sling.
2.
Install engine assembly (6) in lower container (13).
3.
Install engine assembly (6) on two rear engine mounts (11) with four washers (7), lockwashers (8),
and capscrews (9).
4..
Install engine assembly (6) on two engine mounts (12) with four washers (7), lockwashers (8), and
capscrews (14).
5.
Remove pin (21) from sling bracket.
Back to Top
