TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 238 of 1258

TM 9-2320-280-34

3-26.

ENGINE PREPARATION (6.2 L AND 6.5 L)

NOTE

•

Perform steps 7 through 13 for vehicles equipped with a 60 amp alternator.

•

Prior to removal, tag all leads for installation.

7.

Remove two screws (6), lockwashers (7), and wire retaining strap (8) from alternator (22) and remove

wire retaining strap (8), spacer (9), and washer (10).

Discard lockwashers (7).

8.

Remove two screws (1) and lockwashers (27) from terminal cover (2).

Discard lockwashers (27).

9.

Pry cover (2) away from waterproofing adhesive and remove cover (2).

10.

Remove waterproofing adhesive from around terminals (23).

11.

Disconnect lead 568A (12) from engine wiring harness (11).

12.

Remove capscrew (3), lockwasher (4), and ground 3B (5) from alternator (22).

Discard lockwasher (4).

13.

Remove two nuts (26), lockwashers (25), washers (24), and leads 5A (10) and 2A (9) from alternator

(22).

Discard lockwashers (25).

NOTE

There has been a change to the power steering lines support

bracket.

Perform step 14 for vehicles with original

configuration.

Perform step 15 for vehicles with new support

bracket configuration.

14.

Remove locknut (18), washer (19), capscrew (21), spacer (20), harness clamp (16), and clamp (17)

from support bracket (15).

Discard locknut (18).

15.

Remove locknut (31), washer (32), capscrew (34), washer (33), harness clamp (28), and clamp (30)

from support bracket (29).

Discard locknut (31).

3-176