TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 397 of 1258

TM 9-2320-280-34

6-6.

STARTER REPAIR (Cont ’d)

16.

Remove two nuts (12), lockwashers (11), screws (8), copper washers (7) and two negative brush leads

(10) from starter motor frame (4).

Disconnect two negative brush leads (10) and remove two brushes

(9).

Discard two lockwashers (11).

17.

Remove two screws (1) and two positive brush leads (2) from field coil (3).

18.

Remove four springs (5) from brush holders (6).

19.

Remove four nut and lockwasher assemblies (14), rubber washers (15), and cover (16) from solenoid

housing (18).

Pull cover (16) away from solenoid housing (18) far enough to allow access to series

winding connection (19) and screw (20).

Discard rubber washers (15) and nut and lockwasher

assemblies (14).

20.

Remove screw (20) and washer (21) from series winding connection (19) on cover (16).

Remove cover

(16) and gasket (17) from solenoid housing (18).

Discard gasket (17).

21.

Hold core shaft (27) and remove locknut (26), washer (25), and contact (24) from core shaft (27).

Remove core shaft (27), washer (22), and spring (23) from solenoid housing (18).

Discard locknut (26).

22.

Remove snapring (31), spring retainer (30), spring (29), spring retainer (28), rubber boot (32), and

washer (33) from core shaft (27).

Discard snapring (31).

6-50