TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 448 of 1258

CAUTION

______

Use care when installing harness. Snagging or pulling may damage

harness.

NOT E

The top screws connecting the closeout plate may be longer than the

rest, if the fuel filter drain tube is routed to the top of the closeout plate.

NOT E

Refer to TM 9-2320-280-20 for repair of wiring harness connectors.

1 .

Position harness (5) in approximate mounting position. Feed forward branch of harness ( 5 )

through hole (20).

2.

Install left body mounts (para. 13-3).

3.

Install grommet (19) over yellow locator tape (22) and position closeout plate (18) on grommet (19).

4.

Install grommet (19) and closeout plate (18) on cowl (23) with four screws (24) and locknuts (21).

5.

Install harness ground lead 57E (8) on heater motor (7) with washer (9) and screw (10).

6.

Connect harness lead 400D (6) to heater motor (7).

7.

Connect harness leads 27K (12), 57F (13), and 71C (±11) to windshield wiper motor jumper harness (3).

8.

Install harness (5) on “A” beam (2) with two clamps (14), capscrews (1), and locknuts (4).

NOTE

Perform step 9 for M1097, A1 and A2 series, and M1123.

9.

Install screw (16) and transfer case indicator lamp ground lead (17) on cylinder head (15).

6-9. BODY WIRING HARNESS REPLACEMENT (Cont'd)

b. Installation

TM 9-2320-280-34

6 - 1 0 0

Change 1

M1097, A1 AND A2 SERIES,

AND M11 2 3