TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 439 of 1258

TM 9-2320-280-34

6-9. BODY WIRING HARNESS REPLACEMENT (Cont ’d)

37.

Remove two screws (31), clamps (32), and harness (33) from body (30).

38.

Remove capscrew (29), nut and lockwasher assembly (27), clamp (28), and harness (33) from body

(30). Discard nut and lockwasher assembly (27).

39.

Remove two screws (14), lockwashers (15), and shield (7) from body (30). Discard lockwashers (15).

40.

Remove two capscrews (6), nut and lockwasher assemblies (21), clamps (22), and harness (33) from

shield (7). Discard nut and lockwasher assemblies (21).

41.

Disconnect harness lead 489A (12) at left rear side marker light (8).

42.

Disconnect harness leads 21C (23), 22-461B (24), 23B (25), and 24B (26) at left rear composite light

(1).

NOTE

Perform step 43 for M1035, M1035A1 and M1035A2 only.

43.

Disconnect harness lead 467E (13) from backup light (20). Remove nut (16), lockwasher (17), and

ground lead 95D (18) from stud (19). Discard lockwasher (17).

44.

Remove locknut (11), screw (9), and harness ground lead 95C (10) from left rear side marker light (8).

Discard locknut (11).

45.

Remove capscrew (5), lockwasher (4), and harness ground lead 95B (3) from buss bar (2). Discard

lockwasher (4).

46.

Remove five screws (35), clamps (36), and harness (33) from body (30).

47.

Remove four capscrews (38), nut and lockwasher assemblies (37), and trailer connector (39) from

bracket (34). Discard nut and lockwasher assemblies (37).

48.

Remove trailer connector (39) from bracket (34).

6-92